We have a Dimsport Dynorace 1000hp 4 wheel drive inertia  
system rolling road, this can test all four and two wheel drive  
vehicles up to 1000hp.

If you decide to have your car tuned on the dyno it will involve us  
strapping your car onto the dyno via the chassis with heavy duty  
car straps, once the vehicle is secure we will then run the car  
engine up to normal operating temperature in preparation for the  
dyno run.

To test the cars current horse power and torque settings we will  
select the correct gear and run the engine to full load for a few  
short seconds and then let the vehicle freewheel so the dyno can  
make all the calculations that is required to display the correct  
information on screen, we will then repeat this test around three  
times to get an average reading.


After we have preformed the remap and uploaded it back into your vehicle we will then run the car  
again and if needed we will make any final adjustments that are required until we are happy with the  
end results, this will then complete the dyno test, you will then receive a printout of the dyno test and it  
will show you the results of the pre runs and of the tuned runs, thus giving the increases made during  
the remap.

Below is a few sample graphs from our Dyno.
All Major Cards Accepted
See Our Special Offer on
Remap & Terraclean Custom Exhaust,
In-House Remap
£200